Things to pay attention to when maintaining a sand and gravel production line

To install a good sand and gravel production line needs to take into account many aspects, which we all know. However, do you understand the considerations when repairing the sand and gravel production line? In the following, I will highlight to you the matters that need attention when repairing the sand and gravel production line, hoping to avoid some unnecessary troubles for you.

1. When it appears that have to use steel wire pliers clamped without handle files, scrapers and other tools work, the operator must be careful to avoid pinching fingers.

2. Regardless of the maintenance of the sand and gravel production line which equipment, all equipment should be in a state of shutdown when repairing.

3. The required tools on hand to prepare a complete, to determine the machine failure, how to repair to do a clear idea, so as to avoid when the parts are assembled down, showing "stuck" situation.

4. After the repair of faulty equipment, to go through a trial run, check, in case the device is found to be less installed parts or equipment still does not work properly.

5. When unloading screws and nuts with tools, use even force, do not be too hasty or strong twisting, so as not to screw the parts.

Sand and gravel production line is not one machine working, but consists of vibrating feeder, jaw crusher, cone crusher (or impact crusher), vertical impact crusher (sand making machine), vibrating screen, sand washer, tape conveyor, electric control system, etc. If one has problems, then it will affect the operation of the whole sand and gravel production line. Therefore, it is still very necessary to know some precautions when repairing the sand and gravel production line.