What causes the production process of the European version of the mill yield becomes low

Recently, many customers reflect the European version of the mill in the production process, its output is not as good as before, a detailed understanding of the customer's situation and the purchase cycle to see may be due to serious wear and tear of the shovel knife, find the reason for the replacement of the new shovel knife will soon solve the problem, regardless of which model of mill, in the use of the process of the phenomenon of reduced output, what is the reason for this? Is it all about the shovel knife? In fact, it is not, the yield reduction has a very aspect of the reasons, the following we will look at one by one:

First of all, the working principle of the European version of the mill and other milling equipment is in its centrifugal force and grinding rollers, grinding ring under the interaction force of grinding powder, the fan will be blown to the analyzer to screen the powder, qualified particles with the wind with the wind into the finished cyclone collector, unqualified is to return to the host milling room grinding and processing again. It is not difficult to see that the factors affecting the output is not only related to the shovel knife, grinding rollers, grinding rings, fans, powder locker and so on have a relationship.

Shovel knife: shovel knife wear is serious, can not produce material grinding roll, grinding ring will be no material to grind;

Grinding roller, grinding ring: grinding roller, grinding ring wear is also heavy, even if the material is sufficient, at this time the fineness of the powder does not meet the standard, the finished product through the screen rate will be very low, will also affect the output;

Fan: fan air volume is more quite a lot, can not afford to blow a grinding into powder;

Powder locker: powder locker is not well adjusted, sealing is not tight, it is likely to cause the powder sucked back, affecting the yield.

Secondly, in addition to the European version of the mill accessories have an impact on its output, the hardness of the material itself, the fineness of the finished product is also an important factor, the material is too hard, in the processing of the rollers, grinding ring is very easy to wear and tear, brief its life; finished product granularity requirements are too fine, the output will be correspondingly reduced, this is not difficult to understand, the same material grinding out the finished product granularity of the different time required will be different, the finer the finished product granularity of the lower output will be.

Finally, the humidity of the material is also one of the factors to consider, the material is too wet will appear in the processing of the phenomenon of tangled rollers, the material rolling effect is seriously affected, the fan blowing up the powder effect is not good, the normal operation of the equipment will be affected, once this situation occurs, must stop to clean up.

Selection of OCP products, we will have professional and technical personnel for you to configure the most suitable production line, and provide you with after-sales technical training, etc., in the installation of the test run and other aspects of the professional personnel responsible for follow-up. Welcome customers to come to visit, negotiate business, and hope that we can sincerely cooperate and create brilliant. Click customer service free consultation, 24 hours online, looking forward to your message.