Impact Crusher in Stone Production Line
In the stone production line, the first process is supplied to the jaw crusher by the vibrating feeder, then the impact crusher, where the jaw crusher plays the role of crushing the large pieces of stone, and then sent to the impact crusher by the belt conveyor, crushing the stone to the size of 20-60 cm, using the plate hammer on the high-speed rotor to produce high-speed impact on the material sent into the crushing cavity and crushed. The crushed material is thrown to the impact plate at the other end of the crushing chamber at high speed along the tangent direction and is crushed again, and then bounces back from the impact plate to the plate hammer and continues to repeat the above process. Due to the high speed throwing of stones, the stones which are not yet ready to fall and the later stones produce collision. This can make better use of material energy and reduce the loss of wearing parts, which can reduce the production operation cost for customers' real.
Whether in the sand production line, stone production line, our purpose is to ensure that the impact crusher, jaw crusher can operate normally and continuously, in order to extend the service life of crushing machinery and equipment, we must carry out periodic maintenance and maintenance of the impact crusher in the process of use, which is an indispensable process. Our factory has done a long idle time for all kinds of crusher equipment before leaving the factory to reduce the failure in the process of future use, our customers in the new machine put into operation, after each shift production run must be a comprehensive inspection of the impact crusher, etc., each part to tighten, belt drive is normal, liner wear a comprehensive understanding of the situation, there are periodic, regular inspection.
At the same time of purchasing the impact crusher, under the guidance of our engineers to understand which are the wearing parts, because the crushing process of large pieces of material will wear the liner plate, impact plate, in the replacement process must follow the principles, first open the rear upper frame, the rear upper frame and the middle box of the coupling bolt removed, and then screwed with a wrench to the hexagonal head part of the flap device, and then the upper frame slowly open. At the same time, you can use the hanging device above the rack to hang to the rear rack. Repeat the above process, that is, after the closure of the upper frame. The impact crusher plate hammer should be adjusted or replaced in time when it is worn to a certain degree to avoid damage to the fasteners and other parts, which will cause more losses.
Impact crusher plays an important crushing role in the stone production line, before the problem does not appear, it must be checked in detail, not gullible and careless, so as not to lose a lot because of the small, resulting in the failure to work properly operation.
Do a good job with the equipment is our purpose, but also our pursuit, our company is always committed to more and better mining machinery and equipment development and research, if you are interested in our products, or want to field visit our production base, please contact the website customer service, 24 hours a day for your service!
