Maintenance knowledge of cone crusher
In addition to the correct operation process, daily maintenance work can also extend the service life of the crusher and improve the efficiency of the crushing equipment, in order to make the operation more comprehensive to understand the maintenance knowledge, the following article will be a comprehensive introduction to the cone crusher maintenance knowledge.
1. bearing field is the most easily damaged parts, because in the use of wear and tear is larger so need regular maintenance, bearing oil temperature rise, should immediately stop to check the cause and to eliminate.
2. Newly installed wheel hoops and liners are prone to loosening, so they should be checked frequently.
3. Put the movable device of the bottom frame plane, should remove dust and other things to avoid the machine encounter can not crush the material when the movable bearing can not move on the bottom frame, so that serious accidents occur.
4. After installation, check whether the bolts of each part are loose and whether the door of the main machine is tightened, if so, please tighten it.
5. Mainly used to replace the oil, fuel oil, antifreeze measures to increase the freezing facilities. Organized by the department, operation supervision and inspection and supervision of use.
6. Rotating gears in operation if there is an impact sound should immediately stop to check and eliminate .
7. To have iron removal device to prevent the crushing cavity over iron, if frequent over iron, it may cause broken shaft accidents.
8. often pay attention to and timely lubrication of the friction surface of the jaw crusher work to ensure normal operation and extend the service life of the equipment. Add for 50-70%, bearing capacity grease must be replaced every three months, oil change, the application of clean gasoline or kerosene carefully clean roller bearings. Bracket and bracket pad contact, into the crusher grease before the start.
9. Lubricating oil should be replaced frequently, can not be too dirty, too dirty will accelerate the gear and bowl-shaped tile, bushings and other wear, and even make the bushings research dead.
10. drive belt installation can not be too tight, otherwise it will cause the drive shaft rotation inflexible or fracture. Can not be too loose, otherwise it will cause the crusher bogged down.
If you are interested in our products, or want to visit our production base, please contact our customer service, 24 hours for your service!
